Three-dimensional imaging of crack growth in L chondrites after high-velocity impact experimentsOPEN ACCESS
Tatsuhiro Michikami, Axel Hagermann, Akira Tsuchiyama, Hirotaka Yamaguchi, Terunori Irie, Keita Nomura, Osamu Sasaki, Michihiko Nakamura, Satoshi Okumura, Sunao Hasegawa
Planetary and Space Science
In Press, Accepted Manuscript, Available online 11 July 2019
“Highlights
• Most cracks within chondrules and troilite grow regardless of the boundary surfaces of the grains during impacts.
• Most cracks within ductile Fe-Ni metal grow along the boundary surfaces of the grains during impacts.
• The Itokawa particles are shown to be not the products of thermal fatigue but impact fragments on the asteroid surface.”
“Small asteroids such as Itokawa are covered with an unconsolidated regolith layer of centimeter-sized or smaller particles. There are two plausible formation mechanisms for regolith layers on a sub-kilometer-sized asteroid: (i) fragments produced by thermal fatigue by day-night temperature cycles on the asteroid surface and (ii) impact fragment. Previous studies suggest that thermal fatigue induces crack growth along the boundary surface of the mineral grain while impact phenomena may induce crack growth regardless of the boundary surface of the mineral grain. Therefore, it is possible that the crack growth within a mineral grain (and/or a chondrule) differs depending on the crack formation mechanism, be it thermal fatigue or an impact.
In order to investigate how mineral grains and chondrules are affected by impact-induced crack growth, we fired spherical alumina projectiles (diameter ∼1 mm) into 9 mm side length cubic targets of L chondrites at a nominal impact velocity of 2.0 km/s. Before and after the six successful impact experiments, the cracks within mineral grains and chondrules in the respective targets are examined using X-ray microtomography at a resolution with the voxel size of 9.0 μm. The results show that most cracks within chondrules and troilite (FeS) grow regardless of the boundary surfaces of the grains while most cracks within ductile Fe-Ni metal grow along the boundary surfaces of the grains. This may indicate that crack growth is largely affected by the strength of mineral grains (and/or chondrules). From the experimental results and the fact that the shapes of polymineralic and monomineralic particles from Itokawa are similar, we conclude that the Itokawa particles have not been produced by thermal fatigue but instead are likely to be impact fragments, as described in previous papers (Tsuchiyama et al., 2011, 2014; Michikami et al., 2018).”
